Ways to relocate a baby grand piano

Pianos routinely make movers yearly list of items that are most frequently damaged. Grand pianos are especially bothersome. Practicing the following procedures for disassembling, cushioning and loading grand pianos will avoid damage, lower claims expenditure, and improve consumer complete satisfaction.

1) At least three individuals are needed to manage a baby grand piano. If the child grand piano needs to go up or down stairs or if a complete or concert grand piano needs to be carried, a minimum of four people are required.

2) Constantly complete a comprehensive and precise stock. It may be required or more effective to use a visual stock to properly describe and show pre-existing damage.

3) As different parts are taken apart, please location all hardware in an effectively identified parts bag and after that put the parts bag in a "Parts Box".

4) Get rid of the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a clean furnishings pad.

5) Disconnect the lid by removing the hinge pins. Wrap the cover in a tidy furniture pad.

6) Remove the prop that holds the cover open and wrap it in a clean furniture pad. The prop has a hinge pin and remains in 2 pieces.

7) Get rid of the pedal assembly and wrap it in a tidy furnishings pad. When removing the screws, please be cautious not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by placing a piece of masking tape with the proper number on each rod.

8) Pad the piano by putting a tidy rolled furnishings pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to prevent it from flopping open while you deal with the piano. Cover the top of the piano with 2 clean furniture pads, nicely folded around the keyboard. Usage elastic band to protect the pads. Keep in mind: Please make sure that the surface of the piano is dust-free before padding it. Padding a highly refined surface area that is dirty might cause fine scratches, particularly on a black lacquer surface.

9) Position a piano board and attach the straps so that it is prepared to receive the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.

10) Remove the left front have a peek here leg by placing one person underneath the piano at the left end of the keyboard. The other two people need to support the left front corner. The individual beneath the piano should turn the retaining block so that the long end points away from the leg. The screws, if there are any, need to then be eliminated. The "below" individual ought to then extricate the piano before in fact getting rid of the leg. Be sure to have 2 individuals raising the corner of the piano while the third person eliminates the leg. Note: Please make certain to note which legs were gotten rid of from which positions because some pianos have legs that are not interchangeable.

11) Place the piano on the piano board by reducing the "leg-less" end onto the board. Please make certain to lift the entire piano somewhat while finishing this maneuver to prevent unnecessary pressure on the staying, attached legs as the piano suggestions. Raise the piano to an upright position on the board. Keep in mind: Please make sure that the soundboard is secure before lifting. Make sure that the piano is focused comfortably versus the brace at the end of the piano board. Keep in mind: Never ever leave the piano ignored. Constantly have at least one individual holding the piano consistent at all times.

12) Remove the 2 staying legs and wrap them in clean furniture pads. These legs are held in place by a "key and slot" plan. To get rid of the leg, slide it inward toward the center of the piano until it comes out of the slot.

13) Protect the piano to the piano board by bringing completions of the straps together and securing them. Place folded burlap pads over the furnishings pads but under the straps to provide extra security to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, connect the loose ends of the two straps together.

14) To move the piano over a flat, level surface area, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, use the piano board as a skid. After adequately padding the stairs for defense against house damage, put the keyboard end of the piano towards the bottom of the stairs. Attach a bulge strap to the top end of the piano board to avoid the piano from slipping.

16) To load the piano, leave it on the piano board and location it in a tier as the first base product with the keyboard facing the wall of the preceding tier. The very best location to pack the cushioned lid is between the piano and the preceding tier or in between the piano and the wall.

Grand pianos represent a substantial difficulty, they can be moved without damage by using common sense and practicing the treatments listed above.

Leave a Reply

Your email address will not be published. Required fields are marked *